Installed Guide Shoe (Above Serial No. 3618005223); Installing Crankshaft Assembly With Control Link (Above Serial No. 3618005223); Installed Control Link On Crankcase Guide Pin (Above Serial No. 3618005223); Install Piston To Connecting Rod - Kohler Courage SV470 Service Manual

Section 10
Reassembly
Figure 10-18. Installed Guide Shoe
(Above Serial No. 3618005223).
3. Make sure pivot pin on boss in lower section
of crankcase is clean and free of any nicks, or
surface irregularities. Apply a small amount of
grease to O.D.
4. Apply a small amount of grease to O.D. of guide
pin on PTO side of counterweight and install
the control link. Carefully install the crankshaft
with link (hold in position as required), through
the PTO seal. Slightly rotate the counterweight
assembly and guide the outer end of link over
the stationary guide pin in crankcase. Seat link
and crankshaft fully into place, do not force
either part into position. See Figures 10-19 and
10-20.
Control
Link
Figure 10-19. Installing Crankshaft Assembly with
Control Link (Above Serial No. 3618005223).
10.6
Control
Link
Guide
Pin
Figure 10-20. Installed Control Link on Crankcase
Guide Pin (Above Serial No. 3618005223).
Install Piston Rings
NOTE: For detailed piston inspection procedures
and piston ring installation refer to Section 9
Inspection and Reconditioning.

Install Piston to Connecting Rod

1. Assemble the piston, connecting rod, piston pin,
and piston pin retainers. See Figure 10-21.
Figure 10-21. Assembled Piston and Connecting
Rod.