Copy; Copying Procedure; Load The Documents - Xerox CopyCentre C123 User Manual

3 Copy

This chapter contains information on the copy screens and the features available.
NOTE: Some of the features described in this chapter are optional and may not apply
to your machine configuration.

Copying Procedure

This section describes the basic copy procedure. Before making copies on the
machine, confirm what is to be copied and the number of copies required. Follow the
steps below.
1. Load the Documents – page 43
2. Select the Features – page 45
3. Enter the Quantity – page 46
4. Start the Copy Job – page 46
5. Confirm the Copy Job in the Job Status – page 46
Stop the Copy Job – page 47
NOTE: If the Authentication feature is enabled, you may need an account number
before using the machine. To get an account number or for further information, contact
the Key Operator.

1. Load the Documents

Document input areas are as follows.
• Document feeder for single or multiple documents
• Document glass for single documents or bound originals
NOTE: The document glass cover will be fitted in the non-document feeder
configuration.
NOTE: The machine automatically detects standard document sizes. The sizes that
can be detected vary depending on the paper size table specified by the Key
Operator. For more information on setting the paper size table, refer to Paper Size
Settings in the Setups chapter on page 198. If the document is of a non-standard size
or not identified as a standard size, the machine will prompt you to check the
document or manually enter the document size. For information on how to enter a
document size manually, refer to Original Size on page 58.
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 User Guide 43