Error And Maintenance Messages - Brother DCP-1510 User Manual

Error and maintenance messages

The most common error and maintenance messages are shown below.
If you need more help, the Brother Solutions Center offers the latest FAQs and troubleshooting
tips:
Visit us at http://solutions.brother.com/.
Error Message
Cartridge Error
Put the Toner
Cartridge back
in.
Comm.Error
Cooling Down
Wait for a while
Disconnected
Document Jam
Drum End Soon
Replace Drum
Out of Memory
62
Cause
The toner cartridge is not
installed correctly.
Verify you are using a genuine
Brother toner cartridge.
Poor telephone line quality
caused a communication error.
The inside of the machine is
extremely hot.
The other person or other
person's fax machine stopped
the call.
The document was not
inserted or fed correctly, or the
document scanned from the
ADF was too long.
It is time to replace the drum
unit.
The drum unit counter was not
reset when a new drum was
installed.
The machine's memory is full.
Action
Put the toner cartridge firmly into the drum unit,
and then put is back in the machine.
Use only a genuine Brother Original drum unit
and genuine Brother Original toner cartridge.
Try sending the fax again.
The machine will pause its current print job and
go into Cooling Down mode. Wait until the
machine is in Ready mode.
Try to send or receive again.
Pull the jammed paper out of the ADF unit.
(MFC-1810, MFC-1811 and MFC-1815)
Replace the drum unit or reset the drum unit
counter when a new drum is installed. (See the
instructions that are supplied with the new
drum unit.)
Fax sending or copy operation in process
Do one of the following:
Press Start to send or copy the scanned

pages.
 Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Print operation in process
 Press Stop/Exit. The machine will cancel
the print job and clear it from the memory.
 Lower the print quality.
(See Software User's Guide: Printing (for
®
Windows ) or Printing and Faxing (for
Macintosh))
A