Major Components - Xerox DocuColor 7002 User Manual

Major Components

10
9
Number Part
1 On/Off
On
Off
2 User Interface
3 Control Panel
4 Dry Ink/Toner
Compartment
5 Offset Catch Tray
(OCT)
6 Exit Module
7 Right/Left Front
Doors
8 Transport Module
9 Paper Tray 2
10 Paper Tray 1
1-2
2
3
1
8
7
Press the Power Switch to the On position to power on the digital
press.
A screen message advises of a short wait while the Fuser warms
up and the digital press runs a system check.
Press the Power Switch to the Off position to power off the digital
press.
Allow the digital press to remain off for a minimum of twenty
seconds before switching the power on again.
The User Interface contains two components: the Control Panel
and the Touch Screen and is used for messaging and to select
settings.
Allows keypad selection of features.
Contains the Dry Ink/Toner cartridges. The cartridge colors from
left to right, are black, cyan, magenta, and yellow. Refer to the
Maintenance Chapter of this manual for instructions on
changing the cartridges.
Receives completed print job. Sets are offset for easy separation.
Maximum capacity is 500 sheets of 24 lb. (90 g/m
Contains the decurler and the inverter. The decurler removes any
curl from the printed page. The inverter is used when duplexing
or face down output is selected.
Houses the image transfer system for simplex and duplex
printing. Open to clear jams in the paper path in the Printing
Module and at the Fuser. Follow the instructions precisely for
clearing a jam in the Fuser.
The Transport Module carries the paper from the paper trays to
the upper paper path of the digital press.
Holds 2000 sheets of 24 lb. (90 g/m
Holds 2000 sheets of 24 lb. (90 g/m
DocuColor 7002/8002
4
5
6
Description
2
) paper.
2
) paper.
2
) paper.
User Guide