Savin 3045 Operating Instructions Manual page 156

Appendix
Messages/Second messages
IEEE 802.11b (Wireless LAN)
has a problem.
Memory Overflow
Paper in staple tray. Open
Finisher Cover and remove
paper.
Parallel I/F board has a prob-
lem.
Printer font error.
DToner is almost empty.
8
USB has a problem.
150
Causes
IEEE 802.11b interface unit
was not inserted when the ma-
chine was turned on, or it was
pulled out after the machine
turned on.
The settings are not updated
although the unit is detected,
or errors are found while ac-
cessing the unit.
Maximum capacity of PCL or
PostScript 3 list display has
been exceeded.
There is paper remaining in-
side the finisher.
An error has occurred in the
parallel interface board.
An error has occurred in the
font settings.
The toner has almost run out.
An error has occurred in the
USB interface.
Solutions
Turn off the machine and
check the IEEE 802.11b inter-
face unit is inserted correctly.
Then, turn the machine on
again. If the message appears
again, call your service center.
Reduce the value of [Resolu-
tion] in the printer driver. Al-
ternatively, select [Frame
Priority] from [Memory Usage] in
[System] (See p.128 "System").
If this message continues to
appear after taking these
steps, decrease the number of
files sent to the machine.
Open the cover of the finisher,
and remove the paper.
Contact your sales or service
representative.
Check the font settings.
Replace the toner cartridge
with a new one.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.