Input/Output Assign; Monitor Out - Integra DTR-40.3 Instruction Manual

Input/Output Assign

Main Menu

Monitor Out

If you connect your TV to HDMI MAIN output,
"Monitor Out" setting is automatically set so that the
onscreen setup menus are displayed and composite video,
S-Video, and component video sources are upconverted
and output.
Composite video, S-Video,
component video
Composite video, S-Video,
component video
Note
• See "Video Connection Formats"
showing how the "Monitor Out" and "Resolution" settings
affect the video signal flow through the AV receiver.
■
Monitor Out
HDMI Main:
Select this if your TV is connected to HDMI OUT
MAIN.
HDMI Sub:
Select this if your TV is connected to HDMI OUT
SUB.
Both:
Select this if your TVs are connected to HDMI OUT
MAIN and HDMI OUT SUB. Video signals are
output from both HDMI outputs at the resolution
supported by both TVs.
Both(Main):
Select this if your TVs are connected to HDMI OUT
MAIN and HDMI OUT SUB. Video signals are
output from both HDMI outputs but HDMI OUT
MAIN will become a priority; depending on the
resolution, video signals may not be output from
HDMI OUT SUB.
Both(Sub):
Select this if your TVs are connected to HDMI OUT
MAIN and HDMI OUT SUB. Video signals are
output from both HDMI outputs but HDMI OUT
SUB will become a priority; depending on the
resolution, video signals may not be output from
HDMI OUT MAIN.
Note
• When using the DeepColor function, if the "Monitor Out"
setting is set to "Both(Main)" or "Both(Sub)", the number of
bits may be limited due to the capability of your TV connected
to a priority output.
• When video signals of personal computers connected to PC IN
are output from HDMI OUT SUB, they may not display
properly on some TVs.
En
• If you connect your TV to the HDMI SUB output, video signals
44
are output with no conversion.
Input/Output Assign
HDMI
IN
OUT
HDMI
page 85) for charts
(➔
■
Resolution
Through:
Select this to pass video through the AV receiver at
the same resolution and with no conversion.
Auto:
Select this to have the AV receiver automatically
convert video at resolutions supported by your TV.
480p (480p/576p), 720p, 1080i, 1080p
Select the desired output resolution.
1080p/24:
*
Select this for 1080p output at 24 frames per second.
4K Upscaling:
Select this for an output resolution four times that of
1080p, resulting in 3840 × 2160 pixels.
You can specify the output resolution for the HDMI OUT
MAIN and have the AV receiver upconvert the picture
resolution as necessary to match the resolution supported
by your TV.
Note
• Depending on the incoming video signal, the video playback
may not be smooth or the vertical resolution may be lowered. In
this case select anything other than "1080p/24".
• If the "Monitor Out" setting is set to "Both", this setting is fixed
to "Auto".
• When "Monitor Out" is set to either "HDMI Sub" or
"Both(Sub)", the "Resolution" setting is fixed to "Through".