Adjusting The Bass & Treble; Displaying Source Information; Setting The Display Brightness - Integra DTR-30.1 Instruction Manual

Hide thumbs Also See for DTR-30.1:
Table of Contents

Advertisement

DTR-30.1_En_A.book 53 ページ 2009年4月9日 木曜日 午後1時30分
Basic Operations—Continued
–, +, Tone
Press
[Receiver]
first
Dimmer
Adjusting the Bass & Treble
You can adjust the bass and treble for the front speakers,
except when the Direct listening mode is selected.
1
Press the [Tone] button repeat-
edly to select either "Bass" or
AV receiver
"Treble".
2
Use the Tone [–]/[+] buttons to
adjust.
■ Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
■ Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
Note:
This procedure can also be performed on the remote con-
troller by using [Audio] button (see page 86).

Displaying Source Information

You can display various information about the current
input source as follows.
Remote
controller
Display
Note:
This procedure can also be performed on the AV receiver
by using its [Display] button.
The following information can typically be displayed for
input sources.
Input source &
volume
Signal format
or sampling
frequency
Input source &
listening mode
*1 When AM or FM radio is used, the band, preset number, and
frequency are displayed.
*2 If the input signal is analog, no format information is displayed.
If the input signal is PCM, the sampling frequency is displayed.
If the input signal is digital but not PCM, the signal format is
displayed.
Information is displayed for about three seconds, then the previ-
ously displayed information reappears.

Setting the Display Brightness

You can adjust the brightness of the AV receiver's dis-
play.
Remote
controller
Press the [Receiver] button, and
then press the [Display] button
repeatedly to cycle through the
available information.
*1
*2
Press the [Receiver] button, and
then press the [Dimmer] button
repeatedly to select: dim, dim-
mer, or normal brightness.
Alternatively, you can use the AV
receiver's [Dimmer] button (North
American models only).
53

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents