Page 1
MODEL VS102 REVOLUTION PLUS 8.4 VOLTS INSTRUCTIONS FOR USE CHARGE THE VS102 FOR 16-20 HOURS PRIOR TO FIRST USE SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE...
4. Dust Container 8. Charging Jack 13. Gear Box NOTE: CORDLESS SWEEPER MODEL VS102 IS SUPPLIED WITH THE BATTERIES UNCHARGED. CHARGING OF THE UNIT FOR 16-20 HOURS PRIOR TO FIRST USE IS REQUIRED. IMPORTANT SAFEGUARDS To reduce the risk of fire, electrical shock, or injur y when using an...
Page 3
• Use only as described in this manual. Use only manufacturer’s recommended attachments. • Do not use with damaged cord or plug. Do not use cordless sweeper if it has been dropped, damaged, left outdoors, or dropped in water. • Do not abuse the charger cord.
Page 4
SWEEPER ASSEMBLY 1. Unpack and remove the whole 5. Push the handle tubes and the unit from packaging. upper handle together. (Fig.3) NOTE: One metal extension tube has a different black plastic insert. This tube should be inserted into the lower handle.
4. When recharging, make sure the 3. Release the Handle to an unit is in the Off position. optimum position (fig.6). 5. To recharge, repeat step No.1 above. Charging times will vary depending upon the amount of usage between charging cycles. 6.
Page 6
CHANGING THE Lift the brush bar end cap up from the slot. (Fig. 14) ROTATING BRUSH, Pull the brush bar out from the bushing and slip off the GEAR BOX AND belt to remove the brush bar. SQUEEGEE (Fig. 15) Inser t the new brush bar by first inser ting the brush bar WARNING: Use caution when...
NOTE: If uncertain as to how to remove the battery pack, we suggest you take your To achieve the best performance, empty the sweeper to an authorised VAX Service Agent to Dust Container after each use. have this service performed.
Please register your warranty. Send in your completed Warranty Card. If you require any further assistance or advice about your VAX please call VAXCARE on 1300 36 4040 (cost of a local call within Australia) VAX Appliances (Australia) PTY LTD A.C.N.