Renault Scenic Driver's Handbook Manual page 210

TYRE INFLATION KIT
With the ignition on,
– adapter 8 must be connected to
the accessories socket on the dash-
board 9 of your vehicle;
– unscrew the valve cap on the tyre
concerned;
– screw inflation adapter 6 onto the
valve.
– Press the switch 3 to begin inflation;
5.6
(continued)
9
– after a maximum of 7 minutes, stop
inflating and read the pressure (on
pressure gauge 5);
– adjust the pressure: to increase
it, continue inflation with the kit, to
reduce it, press button 7 located on
the inflation adapter;
– if the correct pressure is not achieved,
move the vehicle so that the wheel
is turned forwards or backwards
through several turns to distribute
the repair product, then adjust the
pressure again. If it is still less than
1.8 bar (26 PSI), repair is not pos-
sible: contact a RENAULT Dealer;
3
5
7
8
6
– once the tyre is correctly inflated,
remove the kit (unscrew the inflation
socket, disconnect the accessories
socket, remove the bottle and screw
the valve caps back on);
– keep the kit at hand inside the vehi-
cle and affix the driving recommen-
dation label to the steering wheel;
– start the vehicle, and after driving for
two miles (3 km), stop and check the
tyre pressure again (refer to the in-
formation on Tyre pressures to find
the correct pressure value); if the
pressure is greater than 1.3 bar
(19 PSI), readjust it if necessary then
disconnect the canister and screw
the caps back on. If it is less than
1.3 bar (19 PSI), repair is not pos-
sible: contact a RENAULT Dealer.