ZyXEL Communications NWD-270N User Manual page 56

Chapter 4 Station Mode
Table 15 Profile: Add a New Profile (continued)
LABEL
Scan
Select
2 If you select the Infrastructure network type in the previous screen, skip to step 3. If
you select the Ad-Hoc network type in the previous screen, a screen displays as follows.
Select a Channel number and Wireless Mode and click Next to continue.
To associate to an ad-hoc network, you must use the same channel as the
peer computer.
Figure 40 Profile: Wireless Settings
The following table describes the labels in this screen.
Table 16 Profile: Wireless Settings
LABEL
Wireless Settings
Channel
3 If you selected Infrastructure network type in the first screen, select WEP, WPA,
WPA2, WPA-PSK, WPA2-PSK or 802.1x from the drop-down list box to enable data
encryption. If you selected Ad-Hoc network type in the first screen, you can use only
WEP encryption method. Otherwise, select DISABLE to allow the NWD-270N to
communicate with the access points or other peer wireless computers without any data
encryption, and skip to step 5.
56
DESCRIPTION
Click Scan to search for available wireless devices within transmission range.
Select an available wireless device in the table and click Select to add it to this
profile.
Whenever you activate this profile, the NWD-270N associates to the selected
wireless network only.
DESCRIPTION
Select a channel number from the drop-down list box. To associate to an ad-hoc
network, you must use the same channel as the peer computer.
NWD-270N User's Guide