Kärcher HDS 13/20-4 S/SX Instructions Manual page 34

Electrical symbol
Contactor error
–
 Set the appliance switch to "0/OFF".
 Turn on the appliance.
Error occurs repeatedly.
–
 Inform Customer Service
Fault in the voltage supply.
–
 Check main connections and mains
fuse.
Excessive power consumption.
–
 Check main connections and mains
fuse.
 Inform Customer Service
Water shortage symbol
Water shortage
–
 Check water supply, check connec-
tions.
Burner error symbol
The exhaust temperature limiter has
–
been triggered.
 Set the appliance switch to "0/OFF".
 Allow device to cool down.
 Turn on the appliance.
Error occurs repeatedly.
–
 Inform Customer Service
Error symbol
Leak in the high pressure system
–
 Check high pressure system and con-
nections for tightness.
 Inform Customer Service
34
Flame sensor symbol
The flame sensor turned the burner off.
–
 Inform Customer Service
System care detection symbol
System care detection defective
–
 Inform Customer Service
System care symbol
Note: Burner can operate 5 more hours.
System care bottle empty.
–
 Replace the system care bottle.
Note: Burner operation no longer possible.
System care bottle empty.
–
 Replace the system care bottle.
Appliance is not running
No power
–
 Check power connection/conduit.
Device is not building up pressure
Air within the system
–
Vent pump:
 Set dosing value for detergent to "0".
 With open hand spray gun turn device
on and off multiple times with the device
switch.
 Open and close the pressure/quantity
regulation at the pump unit with the
hand spray gun open.
Note: By dismantling the high pressure
hose from the high pressure connection the
venting process is accelerated.
– 12
EN