Related Manuals for Kärcher HDS Super M Eco
Summary of Contents for Kärcher HDS Super M Eco
- Page 1 HDS Super M Eco HDS Super MX Eco HDS 655 M Eco HDS 695 M Eco HDS 695 MX Eco HDS 895 M Eco HDS 895 MX Eco HDS 1195 S Eco HDS 1195 SX Eco www.kaercher.com 5.961-306 A2008544 05/04...
- Page 2 Deutsch Magyar English Česky Français Slovensko Italiano Polska Nederlands Româneşte Español Türkçe Português Русский Slovensky ÅëëÞíéêÜ ÅëëÞíéêÜ ÅëëÞíéêÜ ÅëëÞíéêÜ Dansk Hrvatski Norsk Srpski Svenska Български Suomi...
-
Page 7: Table Of Contents
English Operating Instructions Contents Warning! Environmental protection Prior to initial operation it is mandatory to read the operating instructions and the Unit illustration notes on safety no. 5.951-949! Operating controls Inform retailer immediately of any transportation damage. Reference to operating instructions Commissioning Environmental protection... -
Page 8: Unit Illustration
10 Cover for tank inlet 27 Motor indicator lamp (not applicablt to 11 Tank inlet für scale inhibitor HDS Super M Eco/HDS Super MX Eco) 12 tank inlet for cleaning agent 28 Ready for working indicator lamp 13 High-pressure nozzle... -
Page 9: Reference To Operating Instructions
English Operating Instructions ! For other water hardnesses request Reference to operating services of a Kärcher service station and instructions have it adapted to local conditions. All of the item numbers described below in the operating instructions are referenced in Filling with fuel the illustration of the unit. -
Page 10: Water Connection
Operating Instructions English Installing the handgun (units Water connection without hose reel) ! See Technical Data for connected loads. ! Connect steel pipe (item 15) with ! Install supply hose at water connection handgun (item 20) (item18) of unit. ! Insert high-pressure nozzle in union nut (supply hose is not part of scope of ! Mount and tighten unit nut delivery) -
Page 11: Operation
English Operating Instructions — Continuous operation is more Mains connection detrimental than operation interrupted by See technical data and rating plate for breaks. connected load. We recommend a medical examination if the unit is regularly used for extensive, Warning! continuous operation and the It is not permissible to exceed the corresponding symptoms (such as, for maximum permissible mains impedance at... - Page 12 Operating Instructions English Setting cleaning temperature Measuring out cleaning agents ! Set the remperature regulator (item 24) — Use cleaning agents sparingly to protect to the required temperature the environment — The cleaning agent must be appropriate 30°C to 90°C for the surface to be cleaned.
- Page 13 1...5 min (do not allow nozzle to dry on). Manufacture no.: Remove dirt: 4.766-023 HDS Super M Eco ! Spray off loosened-up dirt with high- HDS Super MX Eco pressure jet. HDS 655 M Eco HDS 695 M Eco...
-
Page 14: After Every Operation
Operating Instructions English ! Fully open water delivery control at the Stopping machine handgun, in the + direction to the stop. ! Set unit switch (item 23) to "0" See Figure 9 (B) ! Shut off water supply ! Switch the pump briefly on with the unit ! Set operating pressure to minimum switch (item 23) (approx. -
Page 15: Decommissioning
English Operating Instructions Your Kärcher dealer will be pleased to Decommissioning inform you on the performance of regular safety inspections In the event of lengthy periods of non-use and conclusion of a maintenance or if frost-free storage is not possible: contract ! Drain off water and flush out equipment with antifreeze... -
Page 16: Faults
Operating Instructions English Faults Clean strainer in low water protection Fig. 13 Ready for working indicator lamp ! Unfasten union nut and detach hose (item 28) goes out — Motor overloaded/overheated Fig. 14 ! Set selector switch to "0" and allow ! Take out strainer engine to cool off for at least 5 min. - Page 17 English Operating Instructions Unit does not build up pressure Unit does not draw in cleaning agent — Air in system ! Run the unit with an opened cleaning Bleed pump: agent metering valve and a closed water ! Set cleaning agent metering valve supply until the float tank is sucked dry (item 30) to "0"...
-
Page 18: Warranty
Operating Instructions English Set temperature not attained when Warranty working with hot water — Excessive operating pressure/flow rate The warranty terms and conditions issued ! Reduce operating pressure/flow rate by by our responsible sales company apply in way of regulator (Fig. 10) every country. -
Page 19: General Notes
English Operating Instructions Switching on procedures General notes — Switching on procedures generate brief voltage drops. Safety features — Impairments of other appliances can occur in cases of unfavourable mains Overflow valve with two pressure conditions. switches — No problems are to be expected with a —... -
Page 20: Ec Conformity Declaration
Operating Instructions English Measured sound power level: EC conformity declaration HDS 655 85 dB(A) We hereby declare that the machine HDS 695 88 dB(A) specified below as the marketed desigh, HDS 895 89 dB(A) the machine specified below complies with HDS 1195 88 dB(A) the relevant fundamental safety and health...