4.17 RGB harness holder/RGB board/Modem jack
4.17 RGB harness holder/RGB board/Modem jack
Removing the RGB harness holder/RGB board/Modem jack
To remove the RGB harness holder/RGB board/modem jack, follow the steps below and
refer to figures 4-33 to 4-35.
1. Remove the following screw securing the RGB harness holder.
• M2.5×4B
2. Take out the RGB harness holder while unhooking the front latches.
TECRA M2V Maintenance Manual (960-476)
FLAT HEAD screw
RGB harness holder
Figure 4-33 Removing the RGB harness holder
4 Replacement Procedures
×1
M2.5×4B FLAT HEAD
4-51