Display Troubleshooting; Procedure 1 Diagnostic Test Program Execution Check; Procedure 2 Connector And Cable Check; Procedure 3 Replacement Check - Toshiba Tecra M2V Maintenance Manual

2 Troubleshooting Procedures
2.8

Display Troubleshooting

This section describes how to determine if the computer's display is functioning properly.
Start with Procedure 1 and continue with the other procedures as instructed.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector and Cable Check
Procedure 3: Replacement Check
Procedure 1 Diagnostic Test Program Execution Check
The Display Test program is stored on the computer's Diagnostics disk. This program checks
the display controller on the system board. Insert the Diagnostics disk in the computer's
floppy disk drive, turn on the computer and run the test. Refer to Chapter 3, Tests and
Diagnostics for details. If an error is detected, go to Procedure 3.
Procedure 2 Connector and Cable Check
The LCD module is connected to the system board by an LCD/FL cable. The FL inverter
board is also connected to the system board by an LCD/FL cable. The connectors may be
disconnected from the system board or may be damaged. Disassemble the computer
following the steps described in Chapter 4, Replacement Procedures.
If the connection is loose, reconnect firmly and restart the computer. If there is still an error,
go to Procedure 3.
2-40
2.8 Display Troubleshooting
TECRA M2V Maintenance Manual (960-476)