Deleting Scanners - Symantec 10490452 - Mail Security 8220 Administration Manual

190 Administering the system
Managing Scanners

Deleting Scanners

Disable or enable a Scanner
Follow these procedures to disable or enable a Scanner.
To disable a Scanner
1 In the Control Center, click Settings > Hosts.
A red x ( ) in the Enabled column indicates that the Scanner is disabled. A
green check mark ( ) in the Enabled column indicates that the Scanner is
enabled.
2
To disable a Scanner that is currently enabled, check the box next to the
Scanner and click Edit.
3 Click Do not accept incoming messages.
4 Click Save.
5 Allow messages to drain from the queue.
You can check message queue status in Status > Message Queues.
6 Check the box next to the Scanner you want to disable and click disable.
Check as many Scanners as needed before clicking Disable.
The Scanner list updates to reflect your choice.
Clicking Enable for an enabled Scanner or Disable for a disabled Scanner
has no effect on the Scanner.
To enable a Scanner
1
In the Control Center, click Settings > Hosts.
A red x ( ) in the Enabled column indicates that the Scanner is disabled. A
green check mark ( ) in the Enabled column indicates that the Scanner is
enabled.
2 To enable a Scanner that is currently disabled, check the box next to the
Scanner and click Enable.
Check as many Scanners as needed before clicking Enable.
The Scanner list updates to reflect your choice.
Clicking Enable for an enabled Scanner or Disable for a disabled Scanner
has no effect on the Scanner.
When you delete a Scanner using the Control Center, you permanently remove
that Scanner's services from the Control Center. To prevent a Scanner from
continuing to run after deleting it, disable the Scanner before deleting it.