Editing Scanners; Enabling And Disabling Scanners - Symantec 10490452 - Mail Security 8220 Administration Manual

Editing Scanners

Enabling and disabling Scanners

Once you set up a Scanner, you can go back and edit the configuration. For
example, you can suspend the flow of mail or enable different components and
services.
Edit a scanner
Follow either of these procedures to edit a scanner.
To edit a Scanner
1 In the Control Center, click Settings > Hosts.
2 Check the host to edit.
3 Click Edit.
4 Make any changes to the host or its included components and services.
From this page, you can:
Start and stop services
■
Start and stop the flow of data to and from a Scanner.
■
Enable and disable Scanner replication
■
Alter Conduit proxy settings
■
Define SMTP settings
■
Define internal mail servers for your site
■
For more details on these categories, see
settings" on page 20.
To edit a Scanner (alternative method)
1 In the Control Center, click Status > Host Details.
2 Select a host from the drop-down list.
3 Click Configure Host.
4
Make any changes to the host or its included components and services.
See "To edit a Scanner"
make.
For troubleshooting or testing purposes, you can disable and then re-enable
Scanners. Also, It is strongly recommended that you disable a Scanner before
deleting it. Otherwise, you run the risk of losing email messages within the
Scanner email queues. Bear in mind that a Scanner will not process mail while it
is disabled.
"Configuring host (Scanner)
on page 189 for a list of the types of changes you can
Administering the system
Managing Scanners
189