Foxconn Renaissance User Manual page 47

Mhz], [1600 Mhz], [1866 Mhz] and [2133 Mhz].
► DRAM tCL
This item controls the CAS latency, which determines the timing delay (in clock cycles) before
SDRAM starts a read command after receiving it.
► DRAM tRCD
This item allows you to select a delay time (in clock cycles) between the CAS and RAS strobe
signals.
► DRAM tRP
This item allows you to select the DRAM RAS precharge time (in clock cycles).
► DRAM tRAS
This item allows you to set the precharge delay time (in clock cycles).
► DRAM tRRD
This item allows you to set RAS to RAS Delay (in clock cycles).
► DRAM tWR
This item allows you to set Write to Precharge delay (in clock cycles).
► DRAM tWTR
This item allows you to set minimum Write-to-read delay (in clock cycles).
► DRAM tRTP
This item allows you to set the read CAS to precharge time (in clock cycles).
► DRAM tRFC
This item allows you to set Row Refresh Cycle (in clock cycles).
All Voltage Control
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
All Voltage Control
CPU VCore Voltage Control
CPU VTT Voltage Control
Memory Voltage Control
NB Voltage Control
VCore
Target VCore Voltage
VTT
Target VTT Voltage
↑↓→←:Move Enter:Select
► CPU VCore Voltage Control
This item is used to adjust CPU Vcore voltage. The maximum voltage of available adjustment
is "+0.63V". Adjusting the voltage beyond the CPU VCore default voltage could result in damage to
CPU. The CPU Vcore default volatge is "1.1V".
► CPU VTT Voltage Control
This item is used to adjust CPU VTT voltage. The maximum voltage of available adjustment
is "+0.5V". Adjusting the voltage beyond the CPU VTT default voltage could result in damage to
CPU. The CPU VTT default volatge is "1.1V".
ALL Voltage Control
[+0V] [+0V]
[+0V]
[1.500V]
[1.10V]
:1.216 V (+0.00V)
:1.200 V (+0.00V)
:1.674 V (+0.00V)
:1.674 V (+0.00V)
+/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
40
Help Item
The Maximum Voltage of
available adjustment
is "+0.63V"
Warning!!
Adjusting the Voltage
beyond the CPU VCore
default Voltage could
result in damage to
CPU.
the CPU VCore default
Voltage is "1.1V".