Superio Configuration - Foxconn D42S User Manual

SuperIO Configuration

CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
Configure ITE8721 Super IO Chipset
EUP Function
Serial Port1 Address
Serial Port2 Address
Serial Port2 Mode Serial Port2 Mode
Parallel Port Address Parallel Port Address
Parallel Port Mode
Parallel Port IRQ
OnBoard CIR Port
↑↓←→:Move Enter:Select
► EUP Function
When enable, the suspend power of the NM10 Express chipset will be cut off in S5 suspend
mode; when disable, the suspend power is always on.
► Serial Port1 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► Serial Port� Address
This item is used to assign the I/O address and interrupt request (IRQ) for the serial port 2.
► Parallel Port Address
This item is used to assign the I/O address for the onboard parallel port.
► Parallel Port Mode
This item is used to set parallel port mode.
► Parallel Port IRQ
This item is used to assign interrupt request (IRQ) for the onboard parallel port.
► OnBorard CIR Port
This item is used to assign the I/O address for onboard infrared chip.
SuperIO Configuration
[Enabled] [Enabled]
[3F8/IRQ4]
[2F8/IRQ3] [2F8/IRQ3]
[Normal]
[378] [378] [378]
[Normal]
[IRQ7]
[Disabled]
+/-/:Value F10:Save ESC:Exit
F9:Optimized Defaults
30
Help Item
Options
Disabled Disabled Disabled
Enabled
F1:General Help