Memory Configuration; Dram Timing Configuration - Foxconn D42S User Manual

Memory Configuration

CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
Memory Configuration Memory Configuration
DRAM Frequency
↑↓←→:Move Enter:Select
► DRAM Frequency
This item is used to set DRAM frequency. Setting values are: [Auto], [667 MHz], [800 MHz].

DRAM Timing Configuration

DRAM Timing Configuration DRAM Timing Configuration
Configure DRAM Timing by SPD
↑↓←→:Move Enter:Select
► Configure DRAM Timing by SPD
This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a DDR2 memory
module. It contains important information about the module's speed, size, addressing mode
and various other parameters, so that the motherboard memory controller (chipset) can better
access the memory device.
Select [Enabled] for SPD enable mode.
Memory Configuration
+/-/:Value
F9:Optimized Defaults
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
DRAM Timing Configuration
+/-/:Value
F9:Optimized Defaults
[Auto]
[Auto]
Auto
667 MHz
800 MHz
F10:Save ESC:Exit
[Enabled] [Enabled]
[Enabled]
Disabled
Enabled Enabled
F10:Save ESC:Exit
26
Help Item
Options
F1:General Help
Help Item Help Item
Options
F1:General Help