Honeywell HE220 Installation Manual & Owner's Manual page 12

HE220 AND HE260 BY-PASS FLOW-THROUGH HUMIDIFIER
3. Use 1/4 in. (6 mm) OD tubing and connect the saddle valve to the inlet side of
the solenoid valve on the humidifier (see Fig. 9).
a. Place the brass compression nut over the tubing.
b. Install brass insert into end of tubing.
c. Slide the plastic compression ring over the tubing. (Discard copper com-
pression ring provided with valve.)
NOTE: To prevent leaking, use plastic (Delrin) sleeve rings with plastic tubing. Use
copper sleeve rings only with copper tubing.
d. Insert the tubing into the solenoid valve fitting and support the valve while
tightening the compression nut.
NOTE: Do not over-tighten the compression nut. Moderate tightness prevents
leaking.
e. Repeat steps a. through d. for solenoid valve fitting.
69-1111EF—05
VALVE HANDLE
Fig. 8. Installing the saddle valve.
SCREW DRIVER
WATER LINE
M31016
12