The Software Does Not Control The Modem Properly Or Can Not Detect The Modem; The Characters On The Screen Are Doubled; No Text Appears On The Screen In Data Mode; No Text Appears On The Screen When In Command Mode - Multitech MT5634ZLX Owner's Manual

The Software Does Not Control the Modem
Properly or Can Not Detect the Modem
S: Make sure the software has been set up
correctly. Check the initialization string and dial
string.
C: Some TSRs (programs that stay in memory
after they are loaded) may conflict with the
communications software.
S: Try starting your computer without loading any
TSRs.

The Characters on the Screen Are Doubled

C: Both the modem and the software have the
echo feature turned on.
S: Since only one needs an echo, turn the
software echo feature off.
C: The remote modem is echoing your typed
characters.
Type ATE1 then Enter at the command line.
S:
Then turn off the software echo feature.

No Text Appears on the Screen in Data Mode

C: The remote modem is not echoing your typed
characters.
Type ATE0 then press Enter at the command
S:
line. Then turn the software echo feature on.
C: Your software may not be set to use Full Duplex
or the remote modem may not be set to use Full
Duplex either.
C: The remote modem may be waiting for you to
type a command before it will reply with text.
No Text Appears on the Screen When in
Command Mode
S: If you can't see the characters you are typing,
then type ATE1 then press Enter.
4 - Troubleshooting
41