For The User; Important Information - Worcester GREENSOURCE User Manual

Important information for the user

Important information

The Greensource is a family of heat pumps, that extract energy from outdoor
air to produce water based heating and, if required, hot water for your house.
The sizes available are 6, 7 and 9.5 kW.
The Greensource heat pump can only be used in conjunction with the
Worcester Greensource hot water distribution unit.
The heating installation is controlled by a control unit, which is in Green-
source hot water distribution unit. The control unit controls and monitors the
total system using different settings for heating and hot water. The settings
are factory set, however can be adjusted to suit the householders require-
ments.
When the heat pump has been installed and started there are a number of
points you should check regularly. This may concern an alarm triggering or
performing basic maintenance actions. Initially you should perform these
actions on your own. This manual describes each step in detail. If the problem
remains you should contact your installer.
This guide contains a description of the Greensource heat pump, what it
consists of, maintenance, settings etc.
Operating instructions for Greensource hot water distribution unit are
described in its own guide.
Note
Only a trained and qualifi ed technician may carry out repairs to this machine. Incorrect repairs
can lead to serious risks to the user, and a reduction in savings.
Visits from an authorised Service representative to make corrections or adjustments after
such a repair, cannot in such cases be carried out free of charge, not even during the warranty
period.

For the user

4
Note
It is important as the user that you
read through this guide.
Under no circumstances may you
make settings that are designed for
the installer. This can cause serious
malfunction of the heat pump.