Setting The Clock - Fisher & Paykel OR30SDPWIX Installation Instructions And User Manual

Setting the clock

18
US
CA
Buttons
sets the timer
sets the cooking time
sets the stop time for automatic cooking
set the oven temperature /
select Celsius or Fahrenheit
decreases the time and temperature
increases the time and temperature
sets the Self Clean time
starts the oven/starts the Self Clean cycle
Illuminated symbols
If the display shows
flashing
0
steadily lit
A
flashing and
beeping
steadily lit
steadily lit
To set the clock
When the power to the appliance is turned on or restored after a power failure 12:00 will flash in
the display.
1 Press and
2 Press and
3 Rotate the temperature dial or press
will be steadily lit, showing the time is set.
To change the time
1 Press and
2 Rotate the temperature dial or press
After a few seconds the display will remain steadily lit,
showing the time is set.
Note: when the indicator light is at the top the time is set for am
when the indicator light is at the bottom the time is set for pm.
It means that...
12:00
The clock needs to be set.
The oven is set for automatic
cooking.
Automatic cooking has finished
The timer is set
The oven is heating up
together - the display will stop flashing. The clock is now set for 12:00.
together again to change the time. The display will flash
together. The display will flash.
Indicates AM
Indicates PM
For more information
See instructions below.
See section 'Automatic cooking'
See section 'Using the electronic timer'
See section 'Using your oven'
and to set the time. After a few minutes the display
and to set the time.
12:00
A
Clock display and control buttons
Indicates AM
Indicates PM
12