Ariens Zoom XL 42 Manual page 29

PROBLEM
PTO or mower
blades do not
engage or shuts
off.
Engine
overheats.
Unit moves with
engine off and
parking brake
engaged.
Hour meter
continues when
engine not
running.
Unit does not
travel in a
straight line.
Unit creeps with
steering levers
in neutral
position.
PROBABLE CAUSE
1. Operator presence
switch not
depressed.
2. Faulty operator
presence switch.
3. Electric clutch
connector is loose
or disconnected.
4. Faulty PTO belt.
5. Faulty PTO switch,
wires, connectors,
or clutch.
1. Engine oil level
low.
2. Cooling system
plugged.
3. Faulty engine.
1. The parking brake
needs adjustment.
2. Faulty parking
brake.
1. Ignition key is in
the run position
with engine turned
off.
1. Incorrect tire
pressure.
2. Steering levers
need adjustment.
3. Hydrostatic
transmission
and/or linkage
needs adjustment.
1. Hydrostatic
transmission
and/or linkage
needs adjustment.
1. Depress operator presence switch
by sitting on seat.
2. Contact your AriensDealer.
3. Connect the electric clutch
connector. See REPLACING
HYDROSTATIC BELT on page 25
for the electric clutch connector
location.
4. Replace PTO belt (see REPLACING
PTO BELT on page 24).
5. Contact your Ariens Dealer.
1. Add engine oil. Refer to Engine
Manual for detailed instructions.
2. Clean cooling system. Refer to
Engine Manual for detailed
instructions.
3. Contact your Ariens Dealer.
1. Contact your Ariens Dealer.
2. Contact your Ariens Dealer.
1. Turn ignition key to the off position.
1. Check tire pressure (see
SPECIFICATIONS on page 31)
2. Adjust steering levers (see Forward
and Reverse Speed Adjustment on
page 23)
3. Contact your Ariens Dealer.
1. Contact your Ariens Dealer.
GB - 29
CORRECTION