Hydraulic System Maintenance - Ariens Pro Zoom 54 Manual

Engine Oil
Filter
Figure 18
HYDRAULIC SYSTEM
MAINTENANCE
CAUTION: Be sure the engine
has been stopped, the steering
control levers are in the park
position, and the key has been
removed before changing or
checking the hydraulic oil in the
mower.
Allow the hydraulic fluid to cool.
The oil may be hot and could
cause serious burns.
IMPORTANT: Avoid damage to hydraulic
components as a result of contamination. Be
sure to wipe around the filler neck and cap
before removal of the hydraulic oil reservoir
cap. Do not open the oil reservoir cap when
hot unless it is absolutely necessary.
Check the reservoir daily for the proper fluid
level.
The pump and motor units require fluid
changes yearly or every 250 hours whichever
occurs first. The system filter should be
changed initially after the first 50 hours of
operation. The fluid and filter must be
changed and the system cleaned if the fluid
would become contaminated with dirt, water,
etc.
NOTE: The integrated pump/motor units are
equipped with bypass valves. (See Moving
the Unit with the Engine Off on page 23.)
Changing Hydraulic Fluid
Oil Drain
Screw
1. Park the machine on a level surface,
OE3290
2. Clean the area around the reservoir filler
3. To drain the hydraulic fluid, place a
4. Place a thin coat of hydraulic oil on the
5. Install the hydraulic oil filter onto the filter
6. Refill the hydraulic reservoir to the
7. Clean up any fluid which may have
Bleeding/Purging the Hydraulic
System
IMPORTANT: Air in the hydraulic system is
the primary cause of hydraulic pump failures.
Following hydraulic system service or repair,
the hydraulic system MUST be correctly
purged of trapped air before placing the
mower back in operation.
1. To bleed the system make sure the oil
2. Raise the rear unit tires off the floor and
3. Open both pump bypass valves, one on
4. Sitting in the operator's seat, start the
5. Slowly cycle the steering control levers
NOTE: The rear tires should rotate, but they'll
not be under load.
GB - 29
CAUTION: Be sure the engine
has been stopped, the steering
control levers are in the park
position, and the key has been
removed before changing or
checking the hydraulic oil in the
mower.
Allow the hydraulic fluid to cool.
The oil may be hot and could
cause serious burns.
stop the engine, put the steering control
levers in the park position and remove
the key.
cap and remove the filler cap from the
reservoir.
suitable container under the hydraulic
filter and remove it.
gasket on the oil filter. Before
reinstalling, make sure mount area is
clean of debris.
adapter.
recommended level. Reinstall the oil
reservoir filler cap.
spilled.
tank is full, the oil must barely cover the
fill baffle inside of the tank.
place it on suitable jack stands.
each pump, two full turns maximum.
engine and run it at idle.
full forward and full reverse for 10
seconds in each direction, 5 or 6 times.