Staple Finisher-A1/Booklet Finisher-A1/Puncher Unit-Bf1/Inner Booklet Trimmer-A1 (Optional); Replacing The Staple Cartridge In The Stapler Unit - Canon C9075 PRO Operating Manual

Staple Finisher-A1/Booklet Finisher-A1/Puncher Unit-BF1/Inner
Booklet Trimmer-A1 (Optional)
This section describes the procedure for replacement the staple cartridge and removing trim waste from the Booklet Finisher-A1
when the Inner Booklet Trimmer-A1 is installed, and removing punch waste from the Puncher Unit-BF1.

Replacing the Staple Cartridge in the Stapler Unit

1
When the Staple Finisher-A1/Booklet Finisher-A1 is almost out of staples and the staple cartridge in the stapler unit must be
replaced, a screen prompting you to replace the staple cartridge appears on the touch panel display. Follow the procedure
described below to replace the staple cartridge.
Use only staple cartridges intended for use in this machine. See e-Manual > Optional Products (imageRUNNER ADVANCE C9075
PRO/C9065 PRO).
Take care when handling the optional equipment that is attached to the machine. When an optional unit's cover is opened to replace a staple
cartridge, discard the punch waste, discard the trim waste or clear paper or staple jams, prints may still be output if other optional units are
operating normally, and are not involved in the paper or staple jam removal procedure.
•
We recommend that you order staple cartridges from your local authorized Canon dealer before your stock runs out.
•
Remove the orange seal that holds the staples together after you place the staple cartridge into the staple case.
1
Open the front cover of the finisher .
1-42

Staple Finisher-A1/Booklet Finisher-A1/Puncher Unit-BF1/Inner Booklet Trimmer-A1 (Optional)