Problems When Projection Starts; Other Problems - Epson Dreamio EH-TW450 User Manual

Problem Solving

Problems when projection starts

The projector does not turn on
Check
Did you press the [t] button?
Are the indicators switched off?
Do the indicators turn on and off when the power cable is touched? There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If
Is the Control Panel Lock set to Full Lock?

Other problems

No sound can be heard or the sound is faint
Check
Is the audio source connected correctly?
Is the volume adjusted to the minimum setting?
Is A/V Mute active?
Is the audio cable's specification "No resistance"?
The Remote Control does not work
Check
Is the Remote Control light-emitting area pointing towards the
Remote Receiver on the projector when it is operated?
Press the [t] button to turn the power on.
The power cable is not connected correctly or power is not being supplied normally.
Disconnect and then reconnect the power cable.s Quick Start Guide
Check that your electrical outlet or power source is functioning correctly.
this does not solve the problem, stop using the projector, disconnect the power cable from the electrical outlet, and
contact your local dealer or the nearest address provided in the Support and Service Guide.s
Contact List
Press the [t] button on the Remote Control. If you do not want to use Control Panel Lock, change the setting to
Off. s Settings Menu - Control Panel Lock
Disconnect the cable from the Audio port, and then reconnect the cable.
Adjust the volume so that sound can be heard. s
Press the [A/V Mute] button on the Remote Control to cancel A/V Mute.s
When using a commercially available audio cable, make sure it is labeled "No resistance".
Point the remote control towards the Remote Receiver.
Operating ranges Quick Start Guide
Remedy
p.21
Remedy
p.33 s Quick Start Guide
p.16
Remedy
49
Epson Projector