Weslo Momentum 615 Elliptical User Manual page 10

Pulse—This display shows your heart rate when
you use the handgrip pulse sensor.
Scan—When you select this display option, the
upper section of the display will show both time
and distance information, and the lower left sec-
tion of the display will show calories and fat calo-
ries information.
When you
turn the
power on, the
scan display
will be select-
ed automati-
cally. An indi-
cator will
appear below
the word
SCAN to show that the scan display is selected.
As you exer-
cise, the
upper section
of the display
will alternately
show the
elapsed time
and the dis-
tance that you have pedaled; the lower left sec-
tion of the display will alternately show the num-
ber of calories you have burned and the number
of fat calories you have burned. The lower right
section of the display will show your pedaling
speed.
In addition,
the pace
meter on the
right side of
the display will
provide a
visual repre-
sentation of
your pedaling
pace. As you
increase or decrease your pace, bars will appear
or disappear in the pace meter.
To cancel the scan mode, press the Display but-
ton. The indicator below the word SCAN will dis-
appear. The upper section of the display will then
show only the elapsed time, and the lower left
section of the display will show only the number
of calories you have burned. If you press the
Display button again, the upper section of the
Indicator
Pace Meter
10
display will show only the distance pedaled, and
the lower left section of the display will show only
the number of fat calories you have burned. To
select the scan mode again, press the Display
button repeatedly until an indicator appears
below the word SCAN.
To reset the display, press the On/Reset button.
To pause the console, stop pedaling. When the
console is paused, the time will flash in the dis-
play. To continue your workout, simply resume
pedaling.
Measure your heart rate if desired.
5
Note: If there
are sheets of
clear plastic
on the metal
contacts of
the handgrip
pulse sensor,
remove the
plastic. To measure your heart rate, hold the
handgrip pulse sensor, with your palms resting
against the metal contacts. Avoid moving your
hands or gripping the contacts tightly.
When your pulse is detected, the heart-shaped
indicator in the display will flash each time your
heart beats and two dashes will appear. After a
moment, your heart rate will be shown in the dis-
play. For the most accurate heart rate reading,
continue to hold the handgrips for about 15 sec-
onds. Note: If you continue to hold the handgrip
pulse sensor, the display will show your heart
rate for up to 30 seconds. The display will then
show your heart rate along with the other modes.
If your heart rate is not shown, make sure that
your hands are positioned as described. Be care-
ful not to move your hand excessively or to
squeeze the metal contacts too tightly. For opti-
mal performance, clean the metal contacts using
a soft cloth; never use alcohol, abrasives, or
chemicals to clean the contacts.
When you are finished exercising, the con-
6
sole will turn off automatically.
If the pedals do not move for a few seconds, the
time will flash in the display and the console will
pause. If the pedals do not move for a few min-
utes, the console will turn off and the display will
be reset.