Control Panel And Knobs - GE JSP38 Use And Care Manual

OFF BEFORE CLEANING ANY PART
OF THE RANGE.
Proper care and cleaning are important so your radiant
cooktop will give you efficient and satisfactory
service. If soil, mineral deposits from evaporated
water spills or metal rub-off from aluminum
cookware is not removed, it will burn on the glass
cooktop surface and cause permanent discoloration.

Control Panel and Knobs

It's a good idea to wipe the control panel after each
use. Clean with mild soap and water or vinegar and
water, rinse with clean water and polish dry with a
soft cloth.
Do not use abrasive cleansers, strong liquid
cleansers, plastic scouring pads or oven cleansers
on the control panel—they will damage the finish.
A 50/50 solution of vinegar and hot water solution
works well.
The control knobs may be removed for easier
cleaning.
—
the right side are on the proper OFF position. When
replacing the knobs, check the OFF position to insure
proper placement.
Oven Shelves
Clean the shelves
with an
steel wool.
After cleaning, rinse the shelves with
clean water and dry with a clean cloth.
NOTE: The oven shelves may also be cleaned in
the self-cleaning oven. However, the shelves may
darken in color, lose their luster and become hard to
slide if cleaned during the self-cleaning cycle.
"Sure Grip" Handle
The soft door handle is easy to keep clean. Soil will easily wash off
y-duty all-purpose cleaners and detergents, as they may contain
chemicals which might harm the sure grip handle.
abrasive cleanser or
Follow these directions carefully in caring for your
cooktop to assure safe and proper maintenance.
Be sure that the surface unit control knobs are
turned off and that the entire cooktop is cool
before cleaning. Do not use a cooktop cleaner on a
hot cooktop. The fumes can be hazardous to your
health and can chemically attack the glass surface.
The knob stem has a groove in each side. The groove
on one side has a spring clip. The other groove is
clear (see illustration). When removing the knob, it
may be helpful to slip a thin cloth (such as a
handkerchief) or a piece of string under and around
the knob edge and pull up. Check the inside of the
knob and find the molded rib.
Wash the knobs in soap and water or a vinegar and
hot water solution but do not soak.
Replace the knob by fitting the molded rib inside the
knob into the clear groove on the stem.
Clear Groove
in Stem