GE JSP38 Use And Care Manual page 28

OPERATING THE SELF-CLEANING OVEN
How to Set Oven for Cleaning
Quick Reminder:
1. Prepare the oven for cleaning.
2. Close the oven door completely.
3. Press the CLEAN pad.
4. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
If the oven is too hot and you start to set a clean
cycle, the word "OFF" will appear in the display.
Allow additional time for cooling before you try to
set the cycle.
1. Follow directions to prepare the oven for cleaning.
2. Close the oven door.
3. Press the CLEAN pad.
CLEAN
4. Press the INCRE.4SE or DECREASE
displayed.
Clean Time is normally 3 hours. You can
change the Clean Time to anytime between
2and4hours,
soil in your oven.
To Stop a Clean Cycle
1. Press the CLEAR/OFF pad.
1
CLEAR
28
(continued)
dependingontheamountof
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the time for the clean
cycle is set, The words "ON" and "LOCK" will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK light goes off.
5. When the LOCK light is off, open the door
NOTE:
You can find out when the clean cycle will be
finished by pressing the STOP TIME button.
The word "door" will be displayed, the word
"LOCK" will flash and oven control will signal if you
set the clean cycle and forget to close the oven door.
A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
2. When the LOCK light goes off and the oven has
cooled below the locking temperature, open the door.
--