Troubleshooting Tips - GE JGSP28 Owner's Manual

Before you call for service...

Troubleshooting Tips

Problem
Display flashes "bAd"
then "linE" with a
loud tone
Control signals after
entering cooking time
or delay start
Display goes blank
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
"Burning" or "oily"
odor emitting from
the vent
Strong odor
Fan noise
30
Possible Causes
The installed connection
from the house to the unit
is miswired.
You forgot to enter a
bake temperature or
cleaning time.
A fuse in your home may
be blown or the circuit
breaker tripped.
The clock is in
black-out mode.
Power failure.
Oven control pads were
not touched properly.
Power outage or surge.
This is normal in a new oven • To speed the process, set a self-clean cycle for a
and will disappear in time.
An odor from the insulation
around the inside of the oven
is normal for the first few
times the oven is used.
A cooling fan may
automatically turn
on and off.
What To Do
• Contact installer or electrician to correct miswire.
• Touch the BAKE pad and desired temperature or
the SELF CLEAN pad and desired clean time.
• Replace the fuse or reset the circuit breaker.
• See the Using the clock and timer section.
• Reset the clock.
• The BROIL HI/LO and BAKE pads must be touched at
the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
• This is normal. The cooling fan will turn off and on
to cool internal parts. It may run after the oven is
turned OFF.