Oven Vent And Cooktop Air Inlet; Painted Surfaces; Stainless Steel Surfaces - GE JGSP28 Owner's Manual

Care and cleaning of the range.
To order:
To order CERAMA BRYTE ® Stainless
Steel Cleaning Polish and Conditioner,
please call our toll-free number:
National Parts Center. . 800.626.2002
www.GEAppliances.com
CERAMA BRYTE
®
Stainless Steel Cleaning Polish
and Conditioner . . . . . . # PM10X313
Oven vent
Cooktop air inlet
Oven floor
26

Stainless Steel Surfaces

Do not use a steel-wool pad; it will
scratch the surface.
Shake bottle well.
Place a small amount of
CERAMA BRYTE
Cleaning Polish and Conditioner
on a dry cloth or dry paper towel.

Painted Surfaces

Painted surfaces include the top and
sides of the door, and the drawer front.
Clean these with soap and water or
a vinegar and water solution.

Oven Vent and Cooktop Air Inlet

The oven is vented through an opening
in the cooktop under the grille. The
cooktop takes in air through the air inlet
located through the cooktop.
Control Panel
If desired, the touch pads may be turned off
before cleaning.
See the Control Lockout section.
Clean up splatters with a damp cloth.
Removable Oven Floor
To remove the oven floor for easier
cleaning:
Remove the oven door using the
instructions in the Lift-Off Oven Door
section.
Grasp oven floor at the rear finger
slots on each side, lift it up, push it
back and pull it out.
(on some models)
Clean a small area
(approximately 8" x 8"), rubbing
with the grain of the stainless steel
if applicable.
Dry and buff with a clean, dry
® Stainless Steel
paper towel or soft cloth.
Repeat as necessary.
Do not use commercial oven cleaners,
cleaning powders, steel wool or harsh
abrasives on any painted surface.
Never cover these openings with
aluminum foil or any other material.
This would prevent the vents from
working properly.
Remove heavier soil with warm soapy
water. Do not use abrasives of any kind.
Turn on the touch pads after cleaning.
Clean the oven floor with warm
soapy water.
IMPORTANT: Always replace the
removable floor before the next use.