GE JGSP22 Owner's Manual page 30

Before You Call For Service (cont.)...
Troubleshooting Tips
Problem
"F— and a number or
letter" flash in the display
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
"Burning" or "oily"
odor emitting from
the vent
Strong odor
Fan noise
30
Possible Causes
You have a function error code. • Press the CLEAR/OFF pad. Allow the oven to cool for
If the function code repeats.
Power failure.
Oven control pads were
not pressed properly.
Power outage or surge.
This is normal in a new oven
and will disappear in time.
An odor from the insulation
around the inside of the oven
is normal for the first few times
the oven is used.
Improper air/gas ratio in
the oven.
A cooling fan may
automatically turn on and
off to cool internal parts.
What To Do
one hour. Put the oven back into operation.
• Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be pressed
at the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by pressing the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
• To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Using the self-
cleaning oven section.
• This is temporary.
• Call for service.
• This is normal. The cooling fan will turn off and on.