Frame Assembly
1.
Before beginning assembly, make sure that
you understand the information in the box
on page 6. See the PART IDENTIFICATION
CHART on page 5 for help identifying small
parts.
Insert four M8 x 63mm Carriage Bolts (78) up
through the Base (1). Note: It may be helpful to
place a piece of tape over the bolt heads to
hold them in place.
2. Attach the Base (1) and the two Weight Guides
(21) to the Stabilizer (2) with two M10 x 67mm
Bolts (71), two M10 Washers (57), and two M10
Nylon Locknuts (56). Make sure that the indicat-
ed holes in the Weight Guides are nearer the
bottom. Fully tighten the Nylon Locknuts.
Attach the Upright (3) to the Base (1) with the
indicated two M8 x 63mm Carriage Bolts (78) and
two M8 Nylon Locknuts (58). Do not tighten the
Nylon Locknuts yet.
1
2
3
58 71
58
1
78
7
1
78
78
Holes
21
21
57
56
57
2
71