Weider C 625 User Manual page 10

8. Attach the Shroud (17) to the Top Frame (4) with
two M6 x 16mm Screws (62) and two M6
Washers (82).
Attach the Shroud (17) to the brackets on the
Stabilizer (2) with two M6 x 16mm Screws (62)
and two M6 Washers (82). Make sure that the
brackets are inside the Shroud.
See steps 2–7. Tighten the Nylon Locknuts
(56, 58).
Arm Assembly
9. Grease the M10 x 77mm Bolt (79). Orient the Leg
Lever (8) with the welded support as shown.
Attach the Leg Lever to the Front Leg (7) with the
Bolt and an M10 Nylon Locknut (56). Do not
overtighten the Nylon Locknut; the Leg Lever
must pivot easily.
10. Grease the M10 x 77mm Bolt (79). Attach the
Pivot Frame (5) to the Top Frame (4) with the Bolt
and an M10 Nylon Locknut (56). Do not over-
tighten the Nylon Locknut; the Pivot Frame
must pivot easily.
Attach the two Arm Pins (40) to the Pivot Frame
(5) with two M4 x 20mm Self-tapping Screws
(69). Insert the Arm Pins into the two holes in the
Upright (3).
8
82
62
62 82
62
82
9
8
Welded
Support
10
56
69
5
40
10
4
17
Bracket
82
62
56
7
Grease
79
4
79
Holes
Grease
3
69
40
2