Weider 9250 User Manual page 22

ATTACHING THE SEAT FRAME
To attach the Seat Frame (36) to the Front Upright
(42), slide one of the three slots in the bracket on the
Seat Frame onto the pin on the Upright. Note: The
Seat Frame can be adjusted to three different
heights using the three slots. Secure the Seat
Frame to the Upright with the M10 x 80mm Carriage
Bolt (99) and the Seat Knob (49).
For some exercises, the Seat Frame (36) must be
removed. First, make sure that the chain is not
attached to the leg lever. Next, remove the Seat Knob
(49) and the M10 x 80mm Carriage Bolt (99) from the
Seat Frame. Lift the Seat Frame off the Front Upright
(42).
ATTACHING THE LEG LEVER TO THE LOW
CABLE
To use the Leg Lever (29), the seat frame must be
attached to the front upright (see ATTACHING THE
SEAT FRAME above).
Attach one end of the Chain (52) to the end of the
Low Cable (69) by the Front Upright (42) with a Cable
Clip (53). Attach the other end of the Chain to the
bracket on the back of the Leg Lever (29) with anoth-
er Cable Clip.
ATTACHING THE CURL PAD
To attach the Curl Pad (24) to the weight system, the
seat frame must be attached to the front upright (see
ATTACHING THE SEAT FRAME above). Remove the
38mm Square Inner Cap (32) from the Seat Frame
(36). Insert the Curl Post (35) into the Seat Frame and
secure it with the Curl Knob (51).
Always remove the Curl Pad (24) when it is not in use,
and replace the 38mm Square Inner Cap (32).
Slot
99
36
Pin
42
42
69
51
32
22
49
29
53
52
35
24
36