Weider 9250 User Manual page 13

22. Locate the Weight Cable (23), which has a bolt
on each end. Attach the Cable to the Large "U"-
Bracket (90) with an M8 Washer (70) and an M8
Nylon Locknut (3). Do not completely tighten
the Nylon Locknut; it should be threaded only
two turns onto the end of the Cable, as shown
in the inset drawing.
23. Wrap the Weight Cable (23) under a 90mm Pulley
(15). Attach the Pulley and a pair of Pulley
Covers (40) to the Pulley Plates (58) with an M10
x 52mm Bolt (12) and an M10 Nylon Locknut
(21). Make sure the small tabs on the Pulley
Covers are on top.
24. Route the Weight Cable (23) up through the Top
Frame (55). Wrap the Cable around a 90mm
Pulley (15). Attach the Pulley inside the Top
Frame with an M10 x 75mm Bolt (76), two
17.5mm Spacers (77), two M10 Washers (9), and
an M10 Nylon Locknut (21).
25. Wrap the Weight Cable (23) around a 90mm
Pulley (15) and route it down through the Top
Frame (55). Attach the Pulley inside the Top
Frame with an M10 x 80mm Bolt (8), two 17.5mm
Spacers (77), two M10 Washers (9), and an M10
Nylon Locknut (21).
22
90
23
23
23
21
58
40
24
15
55
77
21 9
25
23
55
77
21
13
90
3
3
70
11
Small
Tabs
15
40
58 12
23
77
76
9
15
8
77
9
9