Weider 9250 User Manual page 12

18. Wrap the High Cable (11) around a "V"-Pulley (6).
Attach the Pulley and a Long Cable Trap (50) to
the Left Butterfly Arm (47) with an M10 x 60mm
Bolt (7) and an M10 Nylon Locknut (21). Make
sure the Cable Trap is oriented to hold the
Cable in the groove of the Pulley.
Repeat this step with the Right Butterfly Arm
(48).
19. Wrap the High Cable (11) around a 90mm Pulley
(15). Attach the Pulley to the Pulley Bracket (20)
with an M10 x 47mm Bolt (103) and an M10
Nylon Locknut (21).
Attach the Pulley Bracket (20) to the Top Frame
(55) with an M10 Washer (9) and an M10 Nylon
Locknut (21). Do not overtighten the Locknut
yet.
20. Wrap the High Cable (11) under a 90mm Pulley
(15). Attach the Pulley and a pair of Pulley
Covers (40) to the top hole in the Large "U"-
Bracket (90) with an M10 x 52mm Bolt (12) and
an M10 Nylon Locknut (21). Make sure the small
tabs on the Pulley Covers are on top.
21. Attach the High Cable (11) to the bracket on the
Front Upright (42) with an M10 x 20mm Bolt (98)
and an M10 Nylon Locknut (21).
18
19
55
20
103
9
21
20
Small
Tab
40
21
21
21
11
12
7
50
6
11
47
21
48
11
21
15
11
40
15
12
90
98
42