To Set The Timer - GE JGBC15 Use And Care & Installation Manual

Standard- and continuous-clean models
Table of Contents

Advertisement

Follow the directions below if your range has the clock and timer
shown at the right.
You have the choice of having the timer show the time counting down
or the time of day. In either case, the timer will signal at the end of the ;=
timer period to alert you that the time is up.
To Set the Clock
NOTE: When you first plug in the range or after a
power failure, the entire Cloc~imer display will light up.
1.
Press the CLOCK pad.
2. Press and hold the UP or DOWN pad and the time
of day will change 10 minutes at a time. To change
the time by single minutes, give the pads short taps.
3. Press the CLOCK pad to start the clock.
To Change or Cancel the Timer Setting
When the timer is counting down, use the UP and
DOWN pad to change the remaining time, or press
the TIMER pad to stop the timer. The timer cannot be
instructions above.
Clock
Follow these directions if
your range has the clock and
timer shown at the right.
To set the clock, push in the
knob and turn it to the right.
Let the knob out when the
clock hands reach the correct
time. Continue turning the knob to OFF.
8
CLOCK Am T~ER
To Set the
1.
2. Use the UP and DOWN pads to set the timer.
3. Once you have set your timer, press the TIMER pad
As the timer counts down, a signal will indicate
when one minute is left. After this signal, the display
will count down in seconds. When time runs out, a
final signal will sound. Press the TIMER pad to stop
the signal.
Display Clock While Timer Is Operating
Pressing the CLOCK pad while the timer is operating
will not interfere with the timer's operation; the
display will change to show the clock, but the timer
will continue to count down and will still signal when
time is up. Press the TIMER pad again to change the
display back to show the timer.
Timer
The timer has been combined with the range clock.
12
\
Use it to time all your precise cooking operations.
1
\,\\\. OFF 1
,
1
-.\
4
/,
,
You'll recognize the timer as the pointer that is
different in color than the clock hands.
.
Minutes are marked up to 30, and hours are marked
30
, , \
up to 4 on the center of the clock.
/
6
To set the
pushing in—until the pointer reaches the number of
minutes or hours you want to time.
At the end of the set time, a buzzer sounds to tell
you time is up. Turn the knobwithout pushing
in—until the pointer reaches OFF and the buzzer stops.
(Appearance may vary)
Timer
Press the TIMER pad.
Short taps on the UP or DOWN pad change the
timer's setting one minute at a time. Pressing and
continuing to hold the UP pad increases the setting
ten minutes at a time.
to start timing.
timer,
turn the knob to the left—without

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents