GE JGBC15 Use And Care & Installation Manual page 35

Seal any
openings in the wall behind the range
and in the floor under the range when hookups
are completed.
(for Models Equipped with Standing Pilots)
The range should be installed in its permanent
position before any pilots are lit or adjusted.
Light the Sutiace Burner Pilots
control knobs are in the OFF position before
attempting to light the pilots.
1. Raise the cooktop.
2. Light both pilots with a match.
3. To avoid pilot outage, use caution when
closing cooktop after lighting pilots.
constructed or remodeled home or apartment
that will be unoccupied for more than a month.
Each pilot flame was adjusted at the factory to be
approximately 5/16" tall. A tinge of yellow
appearing at the upper tip is normal. If you find
pilot adjustment is necessary, follow instructions
at right.
of the manifold panel.
3. To adjust, use a blade-we screwdriver with
a shaft diameter of less than 3/16". Turn pilot
adjustment screw until pilot is 5/16" high. Do
not reduce the flame to less than 5/16" or pilot
outage may occur. A pilot flame burning higher
than recommended may generate soot (carbon
black) on the bottom of your cooktop.
Light the Oven Pilot
knob is in the OFF position before attempting to
light the pilot.
1. Remove the broiler drawer by sliding the
drawer all the way out and then lifting slightly to
remove it from it's tracks.
2. hcate the pilot at the
back of the broiler
compartment. The pilot
is attached to the left
side of the oven burner.
3. Light the pilot with a
match. No adjustments ar
required for natural gas.
For LP gas, see How to
Convert the Range for
Use with LP Gas or
Natural Gas section.
35