GE JGBC15 Use And Care & Installation Manual page 42

HOW TO CONVERT THE RANGE FOR USE
To
5. prevent leakage, make sure the orifice
spuds are securely screwed into the gas inlet
tubes. Use a small wrench to hold the inlet tube
hex to prevent it from twisting.
6. Put old orifice spuds back in the bag to save
for possible future conversion.
dropped, the cooktop
can be raised by
the 2 front clips
with a large flat
blade screwdriver.
"engaging
DO NOT attempt to raise the cooktop without
removing all 4 burner bases.
If wires were disconnected to remove the
cooktop, feed wires through the burner holes in
the cooktop. Attach to each burner electrode
terminal carefully, making sure not to bend the
terminal. Then lower cooktop until it snaps
over the clips.
Tall Screw
7. Carefully insert burner bases straight down
with the tube over the ortilce spud. Replace the
screws,
opposite the burner electrode in each
burner base.
42
(continued)
MODELS EQUIPPED WITH STANDARD TWIN
BURNERS
sealed burners.)
1.
2. Lift burner
assemblies
straight up and set
aside to gain
access to surface
burner spuds.
3. With a 5/16" or
small adjustable
wrench, remove
each of the four
spuds on the
surface burner gas inlet tubes and replace them
with the correct gas spuds mounted in a holder
at the right rear of the range, above the
regulator. Natural gas spuds are brass and LP
gas spuds are red or silver. (Mount the spuds
that you removed from the inlet tubes back in
the holder.) To prevent leakage, make sure
spuds are securely screwed into gas inlet tubes.
Electrode
4. Replace the burner assemblies.
5. Keep all spuds with your range so you have
them H you move or get a different gas hook-up.
Top Burner Ofice Drill She
Natural Gas
(for Models Equipped with Standing Pilots)
1.
CONTROL knob.
2.
adjustment screw at left of
thermostat shaft. Turn the .-
screw until the small
pointer stops at LP or N,
depending on the type of gas
you are converting to. The
most the screw will move is
1/2 a turn.
3. Replace the OWN CONTROL knob.
CONVERTING SURFACE BURNERS OH
Step 3 if range is equipped with
(See
Lift cooktop.
#54 (.0550 Dia.)
#66 (.0330 Dia.)
Remove the OWN
Locate the thermostat
Color
Brass
Red or Silver
-
%