GE JGBC15 Use And Care & Installation Manual page 41

MODELS EQUIPPED WITH SEALED BURNERS
(See Step
range is equipped with standard
4 if
Remove the grates, burner caps and burner
1.
heads.
2. Using the torxdriver, remove the burner bases
by unscrewing the 3 small screws in each base.
burner straight out.
disconnect the wires from the burner
DO N~
bases unless the cooktop needs to be raised.
3. Remove the brass ofice spud under each
burner base by unscrewing spud from fitting
with a 7mm or small adjustable wrench
(depending on the size of your spuds).
3/4" wrench to the hex on the gas inlet tube
as a back-up when removing spud to prevent
the aluminum horn twisting.
Install orifice spuds according to one of
4.
the following diagrams (see
gas or natural gas, depending on whicfi you are
converting to.
Apply a
or ) for LP
with this Use and Care Guide. LP orifice spuds
have a 2-digit number and the letter "L" on one
side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on the
range where it is to be installed as shown below.
Natural gas or~lce spuds have a 3-digit number
on one side. Each orflce spud will also have 1, 2
or 3 grooves on one side, with the letter "N"
underneath denoting the location on the range
where it is to be installed as shown below.
Front of Range
(continued next page)
41