Table of Contents
Advertisement
Oven Control, Clock
Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a TIME
BAKE or CLEAN cycle.
To Set the
Clock
Step 1. Touch the CLOCK pad.
Step 2. Press INCREASE or
DECREASE pad to set the time of
Step 3. Touch the CLOCK pad
to start.
Power Outage?
After a power outage, when power
is restored the display will flash
and time shown will no longer be
correct-for example, after a
5-minute power interruption the
clock will be 5 minutes slow. The
display flashes until the clock is reset.
All other functions that were in
operation when the power went out
will have to be programmed again.
and Timer
Timer
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 55
minutes.
To Set The Timer
Step 1. Touch the TIMER pad.
Step 2. Press INCREASE or
DECREASE pad to set the amount
of time on timer.
The timer will start automatically
within a few seconds of releasing
the pad.
The timer, as you are setting it,
will display seconds until 60
seconds is reached.
Then it will display minutes and
seconds until 60 minutes is
reached.
After 60 minutes, it will display
hours ("HR" now appears in
display) and minutes until the
maximum time of 9 hours and 55
minutes is reached.
To Reset
Timer
Touch TIMER pad and then press
INCREASE or DECREASE pad
until the time you want shows on
the display.
To Cancel Timer
Press TIMER pad until the word
"TIMER" quits flashing on the
display (about 4 seconds).
Timer Tones
The timer tone is a steady signal
that repeats every
6
seconds until
you touch any operation. If you
would like to change the tone to a
set of 3 short beeps, press & hold
CLEAWOFF for 10 seconds.
To return the timer tone to a steady
repeating signal, press & hold
CLEAWOFF for 10 seconds.
Display Messages
If "door" appears on the display,
the oven door is in the locked
position. BAKE, BROIL and
COOK TIME cannot be set if the
door is in the locked position.
display, this indicates function
error code. If function error code
appears during the self-cleaning
function, check oven door latch—
the latch handle may have been
moved, even if only slightly, from
the latched position. Make sure
handle is to the right as far as it
will go. Touch CLEAWOFF pad.
If function error code does not
clear, disconnect power to the
range and call for service.
9
Advertisement
Table of Contents
