Table of Contents
Advertisement
PROBLEM
"F-
FLASH IN THE DISPLAY
OVEN WILL NOT WORK
BURN EVENLY
BURNERS HAVE YELLOW
OR YELLOW-TIPPED
BURNER FLAMES VERY
LARGE OR YELLOW
SURFACE BURNERS
LIGHT BUT OVEN
DOES NOT
SURFACE LIGHT DOES
NOT WORK
POSSIBLE CAUSE
If the time display flashed "F- and a number", you have a function error code.
If function error code appears during the self-cleaning cycle, check oven door
latch. The latch handle may have been moved, even if only slightly, from the
latched position. Make sure the latch is moved to the right as far as it will go.
Press the CLEAWOFF pad. Allow the oven to cool for one hour. Rt the oven
back into operation. If the failure code repeats, disconnect all power to the
range. Call for service.
The circuit breaker in your
Oven controls not properly set.
Door left in locked position after cleaning.
Make sure electrical plug is plugged into a live power outlet,
Burner holes on the side or around the top of burner may be clogged. Remove
burners (on models with standard twin burners) or burner heads (on models
with sealed burners) or burner caps on spill-proof models, and clean them
with a sewing needle or twist tie. Make sure you do not enlarge the holes. On
spill-proof models, check electrode area for burned-on food or grease.
-
(A) Yellow flarnes—
If burner flames look Me (A), cdl for service. Normal burner flames should look
like (B) or (C), depending on the type of gas you use.
If range is connected to LP gas, check dl steps in the Installation Instructions.
The oven gas shut off valve may have accidentally been moved during
cleaning or moving.
To check the oven gas shut off valve on standard twin burner models, raise
the cooktop and Iook for the gas shut off lever at the extreme right rear corner.
To check the oven gas shut off valve on sealed burner models, remove the
storage drawer, broiler drawer or kick panel and look for the gas shut off
lever at the back of the range. On some models you may have to remove
an access cover also.
Fluorescent bulb is loose or defective. Adjust or replace.
* Switch operating the light is broken. Call for service.
house has been tripped, or a fuse has been blown.
Normal for natural gas
(continued next page)
49
Advertisement
Table of Contents
