GE JG5P34 Use And Care & Installation Manual page 45

MODELS EQUIPPED WITH SEALED BURNERS
(See Step 4 if range is equipped with standard
twin burners.)
1. Remove grates, burner caps and burner heads.
2. Using a torxdriver, remove the burner bases
by unscrewing the 3 small screws in each base.
DO NOT disconnect the wires from the burner
bases unless the cooktop needs to be raised.
3. Remove the brass orifice spud under each
burner base by unscrewing spud from fitting with
a 7 mm or a small adjustable wrench (depending
on the size of your spuds). Apply a 3/4" wrench
to the hex on the gas inlet tube as a back-up
when removing spud to prevent the
aluminum from tisting.
4. Install or~lce spuds according to one of the
following diagrams (sqe
or natural gas, depending on which you are
converting to.
or ~), for LP gas
orifice
Spuds
with this Use and Care Guide. LP otilce spuds
have a 2-digit number and the letter "L" on one
side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on the
range where it is to be installed as shown below.
Natural gas orifice spuds have a 3-digit number
on one side. Each orfice spud will also have 1, 2
or 3 grooves on one side, with the letter "N"
underneath denoting the location on the range
where it is to be installed as shown below.
(continued next page)
45