Weider 8970 User Manual page 8

8. Attach the Seat Frame (5) to the Front Upright (6)
with an M10 x 70mm Bolt (58), an M10 x 77mm
Bolt (60), three M10 Washers (26), and two M10
Nylon Locknuts (71). Don't over tighten the
Locknut on the M10 x 77mm Bolt; a cable will
be attached to this bolt in step 23.
Attach the Seat Frame (5) to the Seat Upright
(73) with two M10 x 70mm Bolts (58), two M10
Washers (26), and two M10 Nylon Locknuts (71).
Tighten the M10 Nylon Locknuts (71) used in
steps 1–8.
ARM ASSEMBLY
9. Press a 50mm Square Inner Cap (22) into the
Butterfly Frame (9).
Lubricate the M10 x 77mm Bolt (60) with grease.
Attach the Butterfly Frame (9) to the Top Frame
(8) with the Bolt and an M10 Nylon Locknut (71).
Do not overtighten the Locknut; the Butterfly
Frame must be able to pivot easily.
10. Press a 40mm x 50mm Inner Cap (23) into the
indicated end of the Right Butterfly Arm (11). Wet
the bottom end of the Arm with soapy water. Slide
a Large Foam Pad (19) onto the Arm.
Attach a Pivot Bracket (48) to the Right Butterfly
Arm (11) with an M10 x 53mm Bolt (61) and an
M10 Nylon Locknut (71). Do not overtighten the
Locknut; the Pivot Bracket must be able to
pivot easily.
Slide a Foam Grip (76) onto a Butterfly Handle
(12). Press a 31mm Round Inner Cap (24) into the
Butterfly Handle. Attach the Butterfly Handle to the
Right Butterfly Arm (11) with two M8 x 15mm Allen
Head Bolts (64) and two M8 Washers (62).
Slide the Large Foam Pad (19) down so that the
bottom of the Foam Pad is even with the bottom
of the Right Butterfly Arm (11).
Repeat this step with the Left Butterfly Arm (10).
8
60
58
58
26
71
26
9
22
71
9
10
11
62
64
62
19
12
8
26
5
26
6
73
8
Lubricate
60
61
48
23
71
64
24
76
71
10