Troubleshooting - NordicTrack Pro 3000 Treadmill User Manual

TROUBleSHOOTING

Most treadmill problems can be solved by follow-
ing the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assis-
tance is needed, see the front cover of this manual.
SYMPTOM: The power does not turn on
a. Make sure that the power cord is plugged into a
properly earthed outlet (see page 15). If an exten-
sion cord is needed, use only a 3-conductor, 14-
gauge (1 mm ) cord that is no longer than
2
5 ft. (1.5 m).
b. After the power cord has been plugged in, make
sure that the key is inserted into the console.
c. Check the power switch located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the switch has tripped. To reset the
power switch, wait for five minutes and then press
the switch back in.
c
Tripped
Reset
32
SYMPTOM: The power turns off during use
a. Check the power switch (see the drawing above).
If the switch has tripped, wait for five minutes and
then press the switch back in.
b. Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console, and then
reinsert it.
d. If the treadmill still will not run, please see the front
cover of this manual.
SYMPTOM: The console screen remains lit when
you remove the key from the console
a. The console features a demo mode, designed to
be used if the treadmill is displayed in a store. If
the screen shows a demo presentation when you
remove the key, the demo mode is turned on. To
turn off the demo mode, hold down the Stop button
for a few seconds. If the screen is still lit, see step 7
on page 27 to turn off the demo mode.
SYMPTOM: The incline of the treadmill does not
change correctly
a. Calibrate the incline system (see step 4 on
page 28).