Installing Control Box And Adjusting Tilt; Installing Boom And Reel Support - Miller Electric DS-74D16 Swingarc Owner's Manual

4-2. Installing Control Box And Adjusting Tilt

4
3
Tools Needed:
3/8 in

4-3. Installing Boom And Reel Support

4
5
6
1
Tools Needed:
3/8, 3/4 in
OM-1500-13 Page 10
1
2
5
6
7
3
7
2
1 Weld Control
2 Bracket
3 Screw
Bracket and screws are installed
onto bottom of control at factory.
4 Swivel
Loosen screws. Place control on
swivel and slide forward. Tighten
screws.
5 Tilt Bracket
6 Rear Pivot Screw
7 Front Screw
Loosen rear pivot screw. Remove
front screw. Pivot control down-
ward to desired viewing angle. Re-
place and tighten front screw. Tight-
en pivot screw.
803 182
1 Swivel Plates
2 Yoke
Remove hardware from swivel
plates and yoke.
3 Boom
Set boom into swivel as shown.
4 Yoke Pin
Install pin through yoke. Install cot-
ter pin and spread ends.
5 Bolt
Install bolt, washers, and nut. Tight-
en hardware, and back bolt off one
half turn.
6 Locking Knob
Install locking knob but do not
tighten.
7 Reel Support
Install reel support.
ST-153 170-A