Focus; Set Temperature Level And Span - Fluke Ti40FT-20 User Manual

Focus

Remove the lens cap, point the lens at the target, and manually rotate the lens
with your finger, as shown in Figure 1-5, until the image is in focus.

Set Temperature Level and Span

1. Press G as shown in Figure 1-6 to automatically set the camera's
temperature level and span.
2. Press G again as needed to properly scale the image.
Level & Span
Figure 1-5. Focusing the Camera
Figure 1-6. Setting the Level and Span
Introduction
1
Focus
eii005.eps
eii006.eps
1-9