2-4-4 AP Bridge-Point to Multi-Point Mode
In this mode, this wireless range extender/access point will connect to up
to four wireless range extender/access points which uses the same mode,
and all wired Ethernet clients of every wireless range extender/access
points will be connected together. You can use this mode to connect a
network to other networks which is physically isolated.
Please note that when you set your range extender/access point to this
mode, it will not accept regular wireless clients anymore.
When you select 'AP Bridge-Point to Multi-Point', the following options
will be displayed:
Here are descriptions of every setup item:
Band
Please select the wireless band you wish to use. By
selecting different band setting, you'll be able to
allow or deny the wireless client of a certain band.
If you select 2.4GHz (B), 2.4GHz (N), or 2.4GHz
(G), only wireless clients using the wireless band
you select (802.11b, 802.11 Draft-N, or 802.11g)
will be able to connect to this range
extender/access point.
34